Abstract: A 6MV and 15MV electron beams produced by the Elekta precise SL-25 linear accelerator at the Tripoli Medical Center (TMC) were modeled using the MCNP-4C code. Firstly the photon beam energies are tuned by comparison to experimental results previously performed at the TMC. Only the beam energy of the 6MV is modified to 6.2MV. Secondly the percent depth dose curves and beam profiles are calculated for the two energies in different field sizes in the water phantom. Matching with experiment is within an acceptable published allowance of 2%. The distances at which the maximum depth dose in the water phantom is reached are calculated as (1.5cm -1.7cm) for the 6.2MV setting and (2.7cm-3cm) for the 15MVsetting.
خديجة عمر بن ابراهيم (2011)

Dual-energy x-ray absorptiometry (DXA) is an established modality for the assessment of bone mineral density. DXA has also been used for the detection of abdominal aortic calcification (AAC) using lateral images taken for vertebral fracture assessment (VFA). In this phantom study, the capability of VFA for the detection of AAC was investigated. A Perspex phantom of variable width in the range 15-30 cm was used to simulate abdominal soft tissue. Aluminium strips of thickness 0.05-2.0 mm were sandwiched between two halves of the phantom to mimic aortic calcification. VFA images of the phantom were acquired in single-energy mode and analysed by placing regions of interest over the aluminium strip and an adjacent area of Perspex. For each phantom width, the minimum detectable aluminium thickness was assessed visually and related to contrast-to-noise ratio (CNR). Linearity of pixel value with aluminium thickness was tested by linear regression and correlation. Repeatability was measured with five repeated scans for selected phantom configurations. The minimum thickness of aluminium that could be visualised increased with phantom width and varied from 0.05 mm at 15 cm Perspex to 0.5 mm at 30 cm Perspex; the CNR threshold was about 0.03. At all phantom widths, the variation of pixel value with aluminium thickness was strongly linear (r²>0.98, p
Karima Elmasri, William David Evans, Yulia Hicks(6-2017)

There are three main aims that make this study particularly important and interesting to radiometric studies. Firstly, it will provides information on the concentration composition of natural and the associated man-made radioactivity of imported dental porcelain materials to be used by most dental laboratories in Great Jamahiriya. Since these materials do not pass radiation inspection tests before their entry or use and there is a large variety of supply source of these dental materials to be used for all dental works on Libyan patients, anomalies can be identified easily. Secondly, the analysis of selective elemental abundance (U, Th, and K ) and dose rate calculations may be used to calculate effective dose rates to dental laboratory technicians and also to the patient who will be using these specific materials. This research project will provide the first results of such measurements and the corresponding average annual effective dose rates equivalent to the patients using these materials and also to the dental technician and doctors work in the various dental laboratories that make use of these materials in their daily work. A total number of 30 dental powder samples were collected from a number of dental laboratories around Tripoli area will be analyzed. In this research project, the results from this preliminary survey regarding Th, U and K elemental concentrations in a wide variety of dental materials by means of high-resolution X-ray spectrometry will be presented. Further results from these investigations concerning activity concentrations and the associated dose rates, effective dose and the committed dose due to the use of these materials are going to be calculated and compared with other published data elsewhereandrecommendationoftheirusewillbederivedaccordingly. arabic 10 English 74
Karima Mohamed Ali Elmasri, Nouri A. Droughi(9-2010)